Switchblade v2 issues

[Lopes3d]

Got a switchblade connected up, with a r304 receiver and a 3pv tx but can’t seem to get it out of the “double pulsing”. The 3rd channel is activating on the tx as it says it’s up to 100%. Charged up rx battery and fresh batteries in the tx, any thing else to check?

https://www.rcmodelz.co.uk/pub/media/diagrams/Switchblade_Diagram.pdf

 

[spents]

you did get the 3 channel and not the 2 channel switch didnt ya fella ?

 

[Lopes3d]

you did get the 3 channel and not the 2 channel switch didnt ya fella ?

V2 only comes in a 3rd channel variety I believe

 

[KMbaja_Manc]

If you have pressed the 3rd channel button and it's not engaging just double check you have the wires in the receiver plugged in the right way round I had a similar issue. I'm new to 1/5 scale. I got myself a used KM02 last month in like new condition it was the first thing I fitted before taking it out. I also got the same kill switch from RC modelz so just double check your receiver wires mate.

 

[Lopes3d]

If you have pressed the 3rd channel button and it's not engaging just double check you have the wires in the receiver plugged in the right way round I had a similar issue. I'm new to 1/5 scale. I got myself a used KM02 last month in like new condition it was the first thing I fitted before taking it out. I also got the same kill switch from RC modelz so just double check your receiver wires mate.

Legend! Can’t believe I plugged all the servos correct and the kill switch other way round. Surprise surprise works a treat now thanks

 

[KMbaja_Manc]

Legend! Can’t believe I plugged all the servos correct and the kill switch other way round. Surprise surprise works a treat now thanks

Glad you sorted it bud. See sometimes the problem is just staring us in the face