New Kraken Vesla.5

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
I got the stuff man ! Time to administer the graphics to my 30° north body , this is my first time at this type of thing , watched a couple videos , got some advice ,,,well,,,,, on a lot of things from our great moderator sir , on how to use this stuff , paper towel it on let dry and put on the pieces ? But I'm thinking 🤔 m leaning more to the fine brush thing , any input on this quandary is much appreciated
 

Attachments

  • IMG_20221126_130106835.jpg
    IMG_20221126_130106835.jpg
    77.7 KB · Views: 2
@Relic-1 a light even coat is all you need and a brush will just be too much, if you have a micro fiber rag you can cut a 2"x2" piece from will be fine and will carry you through the whole project. It will go on with the same appearance as if you use one of them alcohol wipes so nice light even coat " 1 coat only" and you'll do just fine. Don't worry about painting outside the lines as the graphics hill take up about 98% of all exposed plastic.

But remember you get 1 real good shot at this and you get 1 do over if you didn't lay the whole piece down. Make sure to pay attention as you apply the graphic and push the air bubbles out as you go and make sure to center the piece before you lay it down.
 
You can do the soapy water deal but it will need to be left to dry for a few days in a warm area of the house. Its the same rules as window tint for a car spray soapy water onto the graphics then lay them on and squeegee the water out.
 
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock    No Thanks