Search results

Thanks for posting the conclusion

https://www.rcjuice.com/lipo-batteries/hobbystar-8000mah-14-8v-4s-120c-hardcase-lipo-battery-low-ir.html get yourself some lipo bags https://www.rcjuice.com/leopard-58113-v2-4-pole-brushless-sensorless-motor-for-1-5-scale.html

I think your not supposed to go below 3.2 v when I had my dbxl- e 1.0 my batteries where @120c it use to dump massive power in 10minutes and they where also pretty warm, hot my batteries also use to puff in hard case but the case use to split open and then shrink back I think my esc was set to...

I would remove the spur gear to see if the pinion moves freely if it doesn't then it's the clutch or bearings if it moves freely then it's your transmission I'll do that before anything.

3.80

Put the lipo in storage mode Everytime you are done using it

Did you remove your ignition coil if so you have to gap it with a business card make sure you gap it on the magnetic side of the fly wheel

Have you tried setting the end point the other way........I assign my aux to one of the buttons on the wheel I think d button i first time set up was a female dog but that was because I had a bad kill switch it's easier with a non avc receiver

Assign aux to channel make sure end point is set to 100 check if you can turn KB on and off with switch... proceed to rebind with the KB in the OFF position

Brakes

Lord please have mercy

https://www.rovanrc.com/product-rv450lt-01br

Hello everyone just want some opinions on what octane to use I am looking at vp racing gas and Sunoco. Has anyone used a high octane fuel I have a signature obr 34cc what is the highest value you ever used and what kind of results have you experience ? Thank you .

http://www.davesmotors.com/hostile-17-57t-gear-combo.html

I would start with ride height

http://www.competitionx.com/rc-tuning-guide/

Yes 2 bind plugs with the kill switch off and when you set the kill switch to a channel you have to set that channel end point to100 i forget which way it's a little procedure but you already spent the money you can use the futaba money for when you upgrade good luck I also have a spectrum it...

Keep the radio disable avc on the receiver when hooking up a kill switch if you have any issues with the kill switch call horrizon they can walk you through it

Some guys do some guys don't I don't like running my car's anywhere near water when I first got my 5 I ran it on a rainy day I beat the crap out of that car that day . The motor didn't last long after that.

Thank you for the replies what I used was a vise and some sockets and pressed it out from the outside to the inside just ordered the replacement part from nrp only because I didn't see them on rcmax or Detroit