Search results

Ya I wish I’d spent the money on a different remote for sure

Well I’ve literally tried all of the above and I’m convinced now that the dx5c is not able to kill the engine during signal lose. I’ve tried every possible combination and even holding the F button during bind with no luck? So I’ll just keep the failsafe for brakes and pray nothing bad ever...

Also if this helps it’s on aux2. Input G and Momentary says inhibit ?

Ok so I did exactly as u said and like the dynamite instructions also said and still when I turn off my remote the red light stays on? I can still turn light off and on with the button just fine.

Got ya. Thank u. I’ll try it today

Ok but again how do I do this? Do I turn it off before I put bind plug in receiver or do it while bind plug is in receiver?

Gas is the way to go!! Longer run times. Way cheaper to keep buying fuel. Heck a 5 gal can of mix fuel will last a long time!

I have it assigned to a button and can shut it on and off fine with the button. I guess I don’t understand how to shut it off before I bind it?

How do I shut the kill switch off before I do the bind?

How exactly do u turn it off and then rebind? Do I need to plug in bind first then turn on? Or will my controller even do anything will the receiver is in bind mode?

How do I set the failsafe to shut down my channel with the kill switch? I have the dx5c with sr415

No I mean the battery

after binding am I supposed to put the power wires back on the bind slot or can I leave it in aux 1?

Aux 2. I’m using G on my dx5c

Just got the Losi MTXL and installed the dynamite kill switch. I’m using the dx5c with sr415 non avc. The kill switch works fine when I push the button on the dx5c but when I turn power off on the dx5c the kill switch is still lit up? What am I missing here? I thought it was supposed to also...

I have the same issue. I have the dx5c and sr415 non avc and I can turn on and off with remote but it won’t go off when I shut down remote?