1. P

    KM-GT3B Transmitter issue

    I have a KM-GT3B transmitter that beeps constantly, shows low power with new batteries, but will operate my buggy. I will replace it eventually. Is there a hard reset for this radio?
  2. N

    New Transmitter and Receiver Questions

    hi everyone, I’m new here. I just bought a new Losi 5ive-T with AVC. I am upgrading everything before I run it. All PhatDad driveline stuff, RCMax’s full 7075 version of 7075’s Pro Am Chassis, the 7075 RC Pro Am Front and Rear Diff housings, Billet CNC everything, upgraded servos, Crazy Stu’s...
  3. B

    Transmitter controls are backwards

    Just started to set up my Kraken .5.. every time I hit the gas on my controller it hits the brakes and when I hit the brakes it opens the gas? not sure how to change in my settings ... any recommendations ??
  4. MrFnisse

    New Futaba 3PV or used Futaba 4PK Super-R ?

    So I am getting another Losi and need another Transmitter. Like the title says go for a new 3PV (already have one of these for my other Losi) or go for the used 4PK Super-R in good used condition. Kind Regards John
  5. M

    Warning: Spektrum "fail safe" not so safe

    Bound an SR410 to DX2E. Set the fail safe to full brakes in the event of lost signal. The video below shows me testing it out by turning the radio off and on to simulate loss and regain of signal. The first few times behave as expected. However you can see at the end that as soon as it regains...
  6. DaveSidious

    Absima Telemetry Issues

    Hi guys, First time post, but I'm wondering if anyone can help me. I've just gone from 1/10th to 1/5th and got myself a Carson C5. I've upgraded the standard 40mhz to a 2.4ghz controller - an Absima CR4T Ultimate. With the controller I got 3 telemetry units that seem to have very little...
  7. crankestein

    Radio Control Car Action digital copies, vintage

    From 1986 to 95, found it from RCTECH forum, username CTRJ. For those days, grab a cup of your favorite delight, and go vintage mode taking a trip back in time. Once on the page, click on the yellow RCCA link, wait as it takes a while to upload, pdf format.
  8. Whoduh

    Spektrum DX5R

    New Spektrum Radio, DX5R The DX5R gives bashers, boaters and racers an impressive list of pro-class features at a remarkably affordable price. Superb Ergonomics Inspired by the DX6R. Optimized weight distribution and all kinds of adjustments make it easy to thoroughly adapt the DX5R’s...
  9. H

    New Losi 8IGHT-E 1/8 4WD Electric Brushless Buggy RTR w/DX2E 2.4GHz Radio & AVC cost $350usd

    New Losi 8IGHT-E 1/8 4WD Electric Brushless Buggy RTR w/DX2E 2.4GHz Radio & AVC cost $350usd Serious buyer should contact. Email address: [email protected] Whatsapp CHAT or Call : +254703285513 or 00254703285513
  10. madmanandrewk

    Extra-large radio/battery box work in progress

    I've been working on this thing for about two weeks. I don't understand why they made the box so small when there's literally so much more room for it, but I'm hoping to get this thing machined once I get all the details perfect. Will be 100% water tight, unlike the original with gaping holes...
  11. myrcbud

    Telemetry Treatment

    Thought I'd show what I've been up to. Recently purchased a MCD XS5 Factory Team and Futaba 4PX. No pictures of the install, but the XS5 has the upgraded MCD racing clutch,dual steering hitec servos, 7955TG throttle/brake servo, and a killer bee remote kill switch. I've even installed some...
  12. 2Fast

    Do I need a new radio?

    I have a Rovan RC and the radio and receiver that came with it. After a while, I noticed that my turning has become significantly large as I have mentioned in other threads. I have bought a new Hitec HS-5805MG Digital Mega Servo hoping that would solve my issue. It did not. Im I left with...
  13. 2Fast


    I posted something regarding my flysky radio in this section. its posted in electronics.
  14. B

    FLYSKY radio transmitter for a King Motor 1/5th Buggy, help needed to setup brakes.

    hey all, i just received my Buggy and iv been playing around with my remote control settings and cant figure out what setting i have changed that`s affecting my brakes not to work? Cheers
  15. C

    Killerrc Light Kontroller - Spektrum Rx Question

    I purchased the light kontroller from @Killer RC. As I was installing the unit, I noticed that the black plastic connectors that go out to the receiver from the kontroller did not fit into the slots on the stock Spektrum receiver. Is there a modification required to get them to fit? Not sure...
  16. Z

    Spektrum rx woes solved!

    So I just finally fixed all the issues I have been having on my Baja 5B and I want to post my experience in case anyone has the same issue. I originally had a SRS4210 RX when I got the Super Bee kill switch no matter what I tried I couldn't get the kill switch to work on a radio glitch (the aux...
  17. S

    3 channel radios

    Hi everyone, I have a question regarding 3 channel or even possibly 2 channel pistol type radios. It's more to do with their features mostly, now, I'm looking for a 2 or 3 channel 2.4ghz pistol type radio which features dual rate, adjustable end point and exponential settings. My question to you...
  18. 2

    Rcmk radio tray for dbxl

    I am not sure about the rest of you dbxl owners, but I really don't like the brake/throttle set up on dbxl. Seeing how the dbxl is somewhat a rebrand of the rcmk xcr-1000, I wonder if the radio tray from the rcmk will fit the dbxl to change location of the servo to have less slop in the...
  19. V

    Spektrum dx4s avc and telemetry

    Does anybody uses or have used any of these things?ive got a baja 5t and still use my stock tx an rx,feel like its time to move on,so i was looking at this dx4s with the telemetry thing and the avc..but does the avc works on a baja as well?any thoughts on the telemetry?thanks
  20. C

    Car and radio set up help

    Evening all, I haven't been on here for a long time hence the question. I have an Fg Marder and an on road Sportsline car, I bought these around 2007/8 and I have hardly used either of them, I started to upgrade the parts to alloy and so on. The trouble is I have forgotten how they went together...