Big Steering servo requirements?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Jetjoe14

Active Member
Messages
29
Reaction score
13
Location
Ontario
Hello.
Today I ordered a AGFRC A280BVMW 176KG HV servo for the steering on my Kraken Vekta gas buggy.

My question is, All my RX batteries are Spektrum 2s 3000MAH 6.6v LI-FE batteries.
Will this servo even work on these batteries? As on the spec sheet for the servo only shows 7.4V LIPO as the minimum listed.

The Receiver I use is a Futaba R203GF and rated up to 7.4V, just in case it's relevant.

I don't want to damage my cool new servo or fry my RX. Would you run some kind of regulator? to protect the RX from the servo pulling large current through it?

The throttle servo is just the stock Kraken TS560 HV. (Very good throttle/Brake servo and cheap as chips if anyone was wondering)

Electronics has never been my strong point.

I included a insert so you can see the spec sheet for the servo.

Thank you very much for any help or advice.
 

Attachments

  • agfrc-a280bvmw-176-kg-brushless-digital-servo-product-specification-sheet_1100x.webp
    agfrc-a280bvmw-176-kg-brushless-digital-servo-product-specification-sheet_1100x.webp
    72.4 KB · Views: 1
Last edited:
Back
Top