Dunerunner and dominator v2 pipe

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
It bolts to the engine just fine. I'm not sure on if it fits the buggy with out mods.
 
You will have to mod the back of the buggy there was a guy on here going to do the mods and show us but I can not find the blog at the moment. But it is not a direct bolt on but like dad said it willl fit the motor just fine.
 
Thanks rcdad! I appreciate it! Also, why is there not much aftermarket stuff for the dunerunner?
 
That's kinda the story for all the cats, but it's getting better.

You can do wheels, belt drive, clutch & spring, motor, and a pipe with a little modding.

You can fit the Grafil 5b body with some trimming.
 
Just got the dominator pipe v2. Came with a rubber sleeve and hose clamp. Is that the no leak cupler? How do I install it?
 
Like this...

media.nl?id=13601&c=885035&h=3a14a88c557b96a3267f.webp

Lube the pipe and the header with some 2 stroke oil, then slip the hose onto the pipe. Then just use the pipe as leverage and slip the other end of the hose onto the header and put the spring on. Don't use the hose clamp, it'll tear into the hose. Use some zip ties, instead.
 
Last edited by a moderator:
Would it be fine if I just got my fit perfect and then just welded the two peices together?
Click to expand...
The older versions were one piece. The coupling is an improvement. The coupling adds some flex and vibration protection. The one piece design can damage the cylinder. The pipe can push/pull on the engine when your running the car.
 
The two piece design makes installation and removal a lot easier, as well. You don't have to mess with the header bolts or the gaskets when you remove it. Just take the spring off and slide the pipe off.
 
I mounted mine with a steel bracket from the hardware store I will take a pic of mine after work. I have great success with how i did it i even dremmeled the left side of the

shock tower on the inside to get it to sit lower. I also installed modified rc bumper and cage riders will post a pic and let me know what ya think I know its not perfect but hey what is
 
here is the cage risers I used with the rear bumper

DSCF3073.webp

and here is how I mounted it

DSCF3071.webp

Hope this helps :D :D
 
Works great not any movement. I just took my dremmel and gave the shocktower a little sanding to be able to drop the pipe lower and that helped ALOT!
 
Back
Top