For those who have removed the fuel tank and switched sides for the ddm pipe is the process easy?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Westsiderkg

Westsiderkg

Well-Known Member
Messages
85
Reaction score
9
For those who have removed the fuel tank and switched sides for the ddm pipe is the process easy?



Also, are the factory fuel lines long enough after switching sides to reach the carb?



Thanks!
 
westsiderkg said:
For those who have removed the fuel tank and switched sides for the ddm pipe is the process easy?



Also, are the factory fuel lines long enough after switching sides to reach the carb?



Thanks!
Click to expand...

Dunno about the pipe but you can buy fuel line by the foot.
Buy line that you can see through so you can see where the fuel is going.
Which vehicle is it?
 
It's a pain in the ass you have to pull the rear gear box off the drive shaft runs threw the gas tank but it's not to bad.Jave you put blue locktite on all your screws that is metal on metal
 
It isn't too bad the hang up is the center driveshaft. So the rear diff assembly has to come out. The stock fuel lines reach just fine
 
Thanks all. any good directions or videos on how to remove the rear diff? 1st time doing so and appreciate the guidance.
 
Its fairly easy. 9 screws and the whole rear end assembly comes off. I used blue fuel line to match the truck. don't mine the disarray. In the process of replacing the clutch
 

Attachments

  • 1518279993307984887218.webp
    1518279993307984887218.webp
    85.4 KB · Views: 25
I just did mine and while the gas lines are long enough the hoses coming from the tank rested against the pipe. I just used some small zip ties to hold it down so it didnt touch. I used the tank brace closest to the gas cap and the gear housing to secure it down. I flipped my truck many times and it still holding pretty good.
westsiderkg said:
For those who have removed the fuel tank and switched sides for the ddm pipe is the process easy?



Also, are the factory fuel lines long enough after switching sides to reach the carb?



Thanks!
Click to expand...
 
Back
Top