Help!

[newton540]

Hello,

I removed my flywheel last night, (rebuildign the engine and upgrading) and I am having trouble getting that little piece of the shaft, any suggestions? The one that looks like a half circle once removed. TIA

 

[marder69]

You mean the WOODRUFF KEY fella! if it's nice and snug in the shaft with no sign of damage! Just give a good clean and leave as is DON'T!!!!!!! Grease it when refiiting!!!! Hope this help? GETHIN>

 

[newton540]

I am having a problem getting the casing of the thats behind it so I can replace my crankshaft am i doing somethign wrong????:helpsmilie:

 

[marder69]

Do you mean your splitting the base of the engine?

 

[Bigger the Better]

Just pop it off with a screw driver or tap it off with a screw driver and hammer lightly it is just set in place and should pop right out.

 

[newton540]

I have been trying to get it off, i used a screwdriver, channell locks nuthin working!

 

[mylilmarder]

Stuck is life.

Have you tried Heat.

 

[fordfreak05]

grab the woodruf key with vice grips and pry on the vicegrips with a big screwdriver

jason

 

[RAMTech-RC]

Tap one end of the key and it should rotate out of position.