- Messages
- 13,105
Going off others EPA setting is useless. I just went and checked my brake/ throttle settings 62%/78%
Oh my servo??
- Thread starter Armar5t
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 2,522
I get alot of 100%+
- Messages
- 13,105
Refer to post #21 ?
Bluetickduke
Well-Known Member
- Messages
- 481
- Location
- Southeastern kansas
Eff yo couch ?
Armar5t
Active Member
- Messages
- 25
- Thread starter
- #25
So I'm back up and running. This time I chose to bind with out failsafe on. Once bound I set all my endpoints and sub trim. Then bound it again with the kill switch and failsafe active. All fixed up and ready to run.
My dx5c endpoint settings are
Left 110
Right 100
Throttle 67
Brake 93
Sub trim are
Steering 70 L
Throttle. 50 L
My dx5c endpoint settings are
Left 110
Right 100
Throttle 67
Brake 93
Sub trim are
Steering 70 L
Throttle. 50 L
Bluetickduke
Well-Known Member
- Messages
- 481
- Location
- Southeastern kansas
I don't even use sub trim
Glad you got it figured out
Glad you got it figured out
Armar5t
Active Member
- Messages
- 25
- Thread starter
- #27
My servos were way to far off center, so I used the sub trim to get them close then used the normal trim to fine tune them.
@Bluetickduke did you have any issues installing your dominator pipe? Mine doesn't even come close to fitting. Think I need to trim about a 1/2 inch off the header pipe. To get the pipe itself to slide further on.