-Dusty-
Well-Known Member
- Messages
- 138
- Location
- Alberta Canada
So I got everything ready to go finally and I started my break in. Huge problems though.
First problem is that 9 times out of 10 times I turn my 5t on, the throttle servo is glitching like crazy. Unable to drive since it will go full throttle or break back and forth. The one time out of ten it doesn't glitch out and I can drive fine. But there is still tons of servo noise (chatter) Now comes the second problem
I have the Flysky noble and binding and setup was easy and had no issues with the killswitch and such. Huge problem is when I go about 30 ft it goes out of range. On my transmitter it shows a strong signal then bam signal loss.
So I don't know if these two things are related
I read another thread about someone having trouble with range and he moved the ferrite bead close to the rx, thought I would try that but no difference. Hoping I didn't damage the antenna or anything like that.
First problem is that 9 times out of 10 times I turn my 5t on, the throttle servo is glitching like crazy. Unable to drive since it will go full throttle or break back and forth. The one time out of ten it doesn't glitch out and I can drive fine. But there is still tons of servo noise (chatter) Now comes the second problem
I have the Flysky noble and binding and setup was easy and had no issues with the killswitch and such. Huge problem is when I go about 30 ft it goes out of range. On my transmitter it shows a strong signal then bam signal loss.
So I don't know if these two things are related
I read another thread about someone having trouble with range and he moved the ferrite bead close to the rx, thought I would try that but no difference. Hoping I didn't damage the antenna or anything like that.