46u
Well-Known Member
Anyone here have one of these? How much do they cost US?
Like the idea of a cylinder base o-ring.
How many crank case bearings does it run 2,3 or 4?
Was looking at all the engine parts on their website. Looking at the cylinder is this picture of a finished cylinder or just one that has been bored and not honed? I am an engine machinist for years on motorcycles. I do all machine work including but not limited to rebuilding rods, balancing, truing cranks, line boring, cylinder boring, rework heads and so on.
Is the cylinder lining cast into the cylinder or pressed? Do they make over size pistons and can the cylinders be bored over size?
Is there a US distributor?
Sure I will come up with more questions.
Thanks
Jeff
Like the idea of a cylinder base o-ring.
How many crank case bearings does it run 2,3 or 4?
Was looking at all the engine parts on their website. Looking at the cylinder is this picture of a finished cylinder or just one that has been bored and not honed? I am an engine machinist for years on motorcycles. I do all machine work including but not limited to rebuilding rods, balancing, truing cranks, line boring, cylinder boring, rework heads and so on.
Is the cylinder lining cast into the cylinder or pressed? Do they make over size pistons and can the cylinders be bored over size?
Is there a US distributor?
Sure I will come up with more questions.
Thanks
Jeff