Setting up Futaba Receiver & Radio

[alpine4]

I swapped out my spektrum receiver for futaba receiver that came with 4PM radio. I know the Radio and receiver are linked, do I now need to re setup steering and throttle end points? I also installed Killer Bee switch. I plug the switch into Aux 4 on the receiver. Not sure what aux switch that will be programed too. Reading the manual over and over and still a bit confused.

 

[crucialRC]

Yes time to setup end points and set your aux switch. What do you need help with?

 

[alpine4]

Help with adjusting the throttle trim and steering trim. I have been adjusting the steering trim but no real changes with the servo arm. Need to get that figured out. Then how do I assign the right switch to kill the motor. So I guess I need help with all.

 

[crucialRC]

This will help with your throttle and steering end points. I have to go look at my Futaba to remember how to set up the switch since I have both futaba and Sanwa. Give me a few.

 

[alpine4]

Great thanks

 

[crucialRC]

Sorry got caught up on a birthday. 1st I have my killswitch set up for aux3/sw1 on my receiver/transmitter.

Next, these are the menus I used to set it up.

Then...

Now yours would be for aux4 instead, but you get the gist. Hope this helps.

 

[alpine4]

Got it thank you. Works like a charm.