Snappy fuel kit and brass fittings

[Sergio1]

Ok what about the vent all the brass fittings are the same length so it will be inside the fuel when the tank is full.

 

[Guest]

The vent should not touch the fuel. The vent tube should be in just a bit past the gromet.

 

[Guest]

I trimmed my brass fittings accordingly.

 

[rampage idiot]

Yeah, forget trying to get the gromet installed full of tubes. That would be a miracle!

That would be more than a miracle Houdini could not even do that!

 

[rampage idiot]

My grommets went in pretty easily. The trick is to get one side in and press in the other side a little at a time. I used a really dull flat head screwdriver to help press it in.

This is exactly how I do it also

 

[Sergio1]

Ok so last night I finally did it what I did was I used the stock grommet instead of the snappy and drilled a third hole I fitted the brass with the tubing and the one I drilled without it took me 5 minutes and I think the stock grommet it's way better than the snappy at least is what I think.

My fingers still numb from the battle I had with the stupid snappy and the brass fittings just so you know.

 

[Guest]

Good Job!

 

[Deluge1]

Sweet! Whatever works, dude. Glad you got it sorted.

 

[Deluge1]

This is exactly how I do it also

Takes about 2 minutes to get the grommet in this way. Quick and painless.

 

[rampage idiot]

Takes about 2 minutes to get the grommet in this way. Quick and painless.

Yeh I thought it was pretty easy after trying to put it in with the lines already in!

 

[Guest]

Sure...rub it in.

 

[Deluge1]

Got mine in with the brass fittings.