steel gears

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
C

C-Mac

Member
Messages
87
Reaction score
0
Location
Surrey
hello again,


I am currently running all steel gears and I noticed after a few tanks and even before that it rolls forward fine without binding but if I drag my MT backwards there is all kinds of binding in the gears to where it locks up? Is there a reason for this before I start ripping my truck apart again?


Thanks gain for the help
 
Mine was doing that last running. My C shaft was binding because the nut was too damn tight. I loosened it a little bit until it rolled. Ran it and it had no problems after that.
 
What about no brakes when u start running and then 10 to 15 mins in to the run they start working good again ? Thats what mine do LOL cant figure it out.
 
Back
Top