gdl357
Active Member
I remember making this stand for my HPI Savage like it was yesterday. I will try to make the same for the Rampage MT. It keeps the tires off the floor so you can put it on a rack and is not expensive to make
I will be releasing the measurements/plan when I have it fully completed if people are interested, For now all I have is the plans to make it for a HPI Savage
Credit goes to: Original post from West Coast Elite forums by Viper
Whats needed.
Tools:
Ruler
Hacksaw
PVC Pipe Glue
PVC
12 nonthreaded 1/2" T connectors
4 90 Degree nonthreaded 1/2" connectors
4 1/2" nonthreaded caps.
1 Peice of 8ft 1/2" PVC Pipe (To be cut)
Measure and cut 4 8.5 inch pieces of pipe
Measure and cut 4 4.0 inch pieces of pipe
Measure and cut 4 3.25 inch pieces of pipe
Measure and cut 8 1.5 inch pieces of pipe
Assemble as pictured, but do not glue!
thx
I will be releasing the measurements/plan when I have it fully completed if people are interested, For now all I have is the plans to make it for a HPI Savage
Credit goes to: Original post from West Coast Elite forums by Viper
Whats needed.
Tools:
Ruler
Hacksaw
PVC Pipe Glue
PVC
12 nonthreaded 1/2" T connectors
4 90 Degree nonthreaded 1/2" connectors
4 1/2" nonthreaded caps.
1 Peice of 8ft 1/2" PVC Pipe (To be cut)
Measure and cut 4 8.5 inch pieces of pipe
Measure and cut 4 4.0 inch pieces of pipe
Measure and cut 4 3.25 inch pieces of pipe
Measure and cut 8 1.5 inch pieces of pipe
Assemble as pictured, but do not glue!
thx
Attachments
Last edited: