throtle servo choices

[rc_mad]

hey people


just wondering will a Hitec HS-675 MG be enough to power the throtle and rear brake on the FG monster?

let me know

thanks

 

[Bigger the Better]

Not sure, and cannot find info on that servo? I use a HS-5645MG servo.
http://www.hitecrcd.com/servos/show?name=HS-5645MG

Look at the torque number, you will loose a little speed on the throttle but you want as much grunt pulling back on those brakes.

 

[fgbasher]

I always use the 645MG and it handles front cable brakes, throttle, and rear brakes.

 

[rc_mad]

I always use the 645MG and it handles front cable brakes, throttle, and rear brakes.

and is it good enough?


and i have one left was wondering if good enough or sell it and buy a different one

 

[rc_mad]

ive been told my one is the same as the 645 HS-645MG


so should be good til i get my tower pro's :cool2:

going to aim to get the Monster running then will talk upgrades

 

[Bigger the Better]

Nothing wrong with that servo!
http://www.hitecrcd.com/servos/show?name=HS-645MG

 

[fgbasher]

I have had 1 in my MB for 3 years and it has and esp ported 26cc engine and jetpro pipe and the servo stops the beast no problem.

 

[Clubin]

I run a ACE 1015.
http://www.rc-direct.co.uk/ace-rc-ds1015-digital-servo-high-torque-high-speed-p-1839.html
Check those specs.
Pretty darn good.

 

[allanach]

I run a ACE 1015.
http://www.rc-direct.co.uk/ace-rc-ds1015-digital-servo-high-torque-high-speed-p-1839.html
Check those specs.
Pretty darn good.

I use two of these Front & Rear + throttle.

Full alloy heat sink body and steel spline with 14.5 kgs:2guns:

 

[Bigger the Better]

Anyone know of any of these being used?
http://www.hitecrcd.com/servos/show?name=HSR-5990TG