Silent_Chaos
Well-Known Member
- Messages
- 77
- Location
- Beirut, Lebanon
Sup,
So i have a redcat X series with full 7075 parts on it.
One issue I'm having is that the rear Dogbones (they are aftermarket FLM) are slipping from the diff cup and falling out.
Have a Look on how much on the outward it is located, one small suspension travel and the CVD falls out.
Now, I have got a spare upgraded baja diff cup, just to try and see if it can be fit with small mods, it has a pin locking ability that doeant make the pin slide outwards. (FLM is below one)
Now before trying this and turning/mashining, are there any other methods that I can do in which I can overcome this?? I was told to use fuel lines but have no idea how/where.
Any pics and insight would be appreciated. I bet a lot have had this problem before me.
Thanks for your input
So i have a redcat X series with full 7075 parts on it.
One issue I'm having is that the rear Dogbones (they are aftermarket FLM) are slipping from the diff cup and falling out.
Have a Look on how much on the outward it is located, one small suspension travel and the CVD falls out.
Now, I have got a spare upgraded baja diff cup, just to try and see if it can be fit with small mods, it has a pin locking ability that doeant make the pin slide outwards. (FLM is below one)
Now before trying this and turning/mashining, are there any other methods that I can do in which I can overcome this?? I was told to use fuel lines but have no idea how/where.
Any pics and insight would be appreciated. I bet a lot have had this problem before me.
Thanks for your input