Voltage regulator for running 2 Rhino's on steering?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
M

mynameismud76

Well-Known Member
Messages
122
Reaction score
0
Location
Midlands
Would like everyone's input on the subject of voltage regulator for running 2 Rhino's on steering.

Mate of my came across a thread (but can't recall where) that Rhino's circuit boards don't really like it much above 6v.

If voltage regulator is recommended, is there a good one to get?
 
I use Rhinos, our 6.6v LiFe battery packs, no regulator, and never had a servo fry. Maybe I'm lucky.

Also, I always properly set the EPA on my servos too. Many people don't.
 
I read somewhere that Rhinos are very sensitive to voltage, so when I 'went LiPo' in my MT, I decided to install a voltage regulator, and have also fitted a wiring harness, so that the Rx is bypassed other than the signal wire.
I've got 2 Rhinos and 2 Savox 1256TG's on it, so didn't want to stuff the Rx up.
Al.
 
mynameismud76 said:
Would like everyone's input on the subject of voltage regulator for running 2 Rhino's on steering.

Mate of my came across a thread (but can't recall where) that Rhino's circuit boards don't really like it much above 6v.

If voltage regulator is recommended, is there a good one to get?
Click to expand...

I'm sure Mr Oddie will beable to give you the technical ins and outs of it all, just PM him on team5hite or send him an email.
 
Back
Top