Flysky receiver setup questions...

[Snooptalian]

Got a Flysky Noble radio and FGr4 receiver for my Losi 5T that I need to connect up. Question is where do I plug the power in on this? Spektrum RX has a specific port for power, but this just has the 4 channels, plus one that's labeled Sens and another labeled Servo. Channel 1 will be steering, 2 for throttle, 3 lights and then 4 for the killswitch, so where do I plug in the power from the lipo? Sorry for the idiot question...

 

[Rceverywhere]

Like this one? Don't use sens or servo!
You'll need to put the power into any channel and the bind plug in bind hole to bind, after that power can go into the bind slot and four channels can be used. Sens is just for battery voltage read out on transmitter, servo not sure???

 

[Snooptalian]

Like this one? Don't use sens or servo!
You'll need to put the power into any channel and the bind plug in bind hole to bind, after that power can go into the bind slot and four channels can be used. Sens is just for battery voltage read out on transmitter, servo not sure???

View attachment 90259

Yes. That's the same one. Appreciate the info. I'll set it up following your steps. Much appreciated...