Cheap bigbore engine exhuast.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
T

ThatBajaGuy

New Member
Messages
2
Reaction score
0
I need an exhuast for my baja that is good for an OBR engine. It needs to be silenced and I don't want to spend $200 on a pipe. I am considering the kingmotors thor pipe or the silenced DDM dominator pipe but I don't know if they are any good. Any suggestions?
 
@Phill2 how do you like the JetPro? I ordered one 10 weeks ago for my Rampage, still not here. I talked to Dino and he said it’s been crazy, he’s 100 pipes deep in orders!
 
to the op, i run a ddm v2 dom silenced on an obr 34 reed,
it aint bad tbh, but not as quiet as you may be execting (y)
 
Bizzer said:
@Phill2 how do you like the JetPro? I ordered one 10 weeks ago for my Rampage, still not here. I talked to Dino and he said it’s been crazy, he’s 100 pipes deep in orders!
Click to expand...

Great pipe.
I highly recommend them.
Mine is a rear mount on my Rampage Dune Runner.
You may want to get Dino to send you a silencer with it.
Without out it they're VERY loud.
OK for big open areas but put a silencer on if you're going to run it near your neighbours.
 
spents said:
to the op, i run a ddm v2 dom silenced on an obr 34 reed,
it aint bad tbh, but not as quiet as you may be execting (y)
Click to expand...
I have the same pipe. The stock packing within the silencer is pathetic at best. I added some "off road" specific dirt bike packing, wrap it around the core as tight as possible, wrap the od with masking tape and stuff the assembly into the pipe, it helps to lessen the noise.

https://www.denniskirk.com/moose/fi...erm=4585100930732355&utm_content=All+Products
 
Bizzer said:
Yeah, I did opt in for a silencer. I was just curious, they don’t seem to get much love on this forum?
Click to expand...

From what I've read on here over the years lots of people run em.
Polar_Bus said:
I have the same pipe. The stock packing within the silencer is pathetic at best. I added some "off road" specific dirt bike packing, wrap it around the core as tight as possible, wrap the od with masking tape and stuff the assembly into the pipe, it helps to lessen the noise.

https://www.denniskirk.com/moose/fiberglass-muffler-packing-1860-0852.p436619.prd/436619.sku?cid=384086846&aid=1304021006436136&keyword=4585100930732355::&kid=4585100930732355&msclkid=2645ea7be92718fab6898ade48957ff7&utm_source=bing&utm_medium=cpc&utm_campaign=Shopping&utm_term=4585100930732355&utm_content=All+Products
Click to expand...

I just use fibreglass roof insulation on my bikes.
Just grab a bit out of your roof.
 
Jetpro makes a good pipe, but their silenced versions suck. Packing sucks, silencer many times snap, end cap screw loosens and usually eggs the holes out.
 
Z.hb71 said:
So you bought a expensive modded engine and your gunna choke it with a cheap ass pipe 🤦‍♂️🤦‍♂️🤦‍♂️don't be cheap and buy a proper pipe like an olimat bartolone or victory. If you cant afford new then look for used. Hell theres a used victory bigbore on ebay for 120.
Click to expand...
So I've looked at some bigbore pipes and the bartalone and the victory pipes are very hard to find in my country so I'll have to get an olimat. I also found a Jetpro pipe so that is an option but someone said that the silencer breaks so I'm leaning towards the olimat.
 
Back
Top