8k clutch and killer bee issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
R

Rampage mt

Senior Member
Messages
136
Reaction score
1
Location
Nova Scotia canada
So finally got 8k clutch an killer bee super bee Ashely as my 990 and Billit intake and got it all on however when I start the truck it pulls,I have the throttle linkage set right don't know if I have the washers right on clutch though..behind the clutch it goes flat washer on the plate on the motor and the thin washer on the backside of the clutch? And the killer bee does its thing then goes green till I start the truck then it flashes what looks like orange then goes back green but won't let engine run
 
The wavy washers go on the clutch bolts. the flat washers go on closest to the engine- where the clutch bolts screw into. looking at the engine from the clutch side, the engine rotates counter clock wise- there should be little arrows on the clutch shoes - these should be pointing counter clock wise also.
 
If the kill switch won't let it idle you most likely need a better plug. The cheapo stock plug will cause issues with the kill switch.
 
So I got all working however if I run my truck with the body on it will shut down I'm assuming the killer bee is killing the engine cause its to hot? I'm running slightly rich and it seems to run fine without the body on,I can adjust the heat shut off on the kill switch correct?
 
There is no heat cut off for the killer bee. It must be your plug causing killer be to kick off
 
That's what I was thinking but it will run fine without the body on and within 2-3 minutes of me putting that on it will shut off :s I'm gonna try to get a plug today an see if that helps
 
Back
Top