DBXL 2.0 A support between braces on DBXL-E 2.0

[Bridge builder]

Hi!
I heard that due to that the Losi DBXL-E 2.0 is a bit heavy it could bee a good idea too have a support between the front and rear brace.

Anyone who have tried? Is there any link for such piece? And the most important question of them all, is there a piece made of Carbon fiber

 

[Dunc2504]

There will be when you buy some 4mm carbon sheet and cut it out yourself . it is dead easy to work with , just need a dremel, diamond cutting disk and sanding drums. Makes a bit of a mess , but dead easy and very satisfying.
Put masking tape on the sheet and draw on your cut/sand lines and away you go.
Round the edges with fine emery and polish it up , done.

 

[Bridge builder]

Thanks for the tip!

 

[cmbscx10]

Been a while since I've used CF but recall after a good Sanding to CA the ends to seal the fibers.