Airtronics M11 brake mixing question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
D

DreamState

Well-Known Member
Messages
187
Reaction score
0
Location
Florida
Anyone else have an M11. My FG has a separate servo for the front disk brakes and I want to set it up on another channel for brake mixing. When I go to setup and change it from 2channel to 4channel, my throttle and brake no longer work. It shows it moving on the screen but the servo for the throttle does not move. Anyone ever tried to set this up before?
 
DreamState said:
Anyone else have an M11. My FG has a separate servo for the front disk brakes and I want to set it up on another channel for brake mixing. When I go to setup and change it from 2channel to 4channel, my throttle and brake no longer work. It shows it moving on the screen but the servo for the throttle does not move. Anyone ever tried to set this up before?
Click to expand...

You should rebind the rx-tx after switching to 4 channel mode.
I had the same issue... :-)
SzL
 
Sorry, got busy and never made it back on here. When i rebind it kicks my steering servo on but no the throttle.

After switching to 4 channel, rebind, steering works but no throttle in 4 channel mode.

Still have not figured this out.
 
Ok, actually sat down and looked at it tonight. The problem was inside the receiver the piece of plastic that pushes down on the bind button was stuck and was not actually hitting the bind button. Binded by actually pushing that button and all works like it's supposed to.
 
Back
Top