Aluminum steering mount

[maddmike]

5k up front.and.7k rear

 

[maddmike]

But it won't roll tho

 

[Deluge1]

But it spins fine when you turn the clutch bell?

 

[maddmike]

Ya but no free rolling I'm.sorry I'm. Newb still

 

[maddmike]

When I purchased the pro spec racing kit for my dune runner the bearing that holds the pinion gear on the layshaft bearing holder it is a tad thinner. I shimmed cause without it was tight. I hope to get this.running smoothly again cause it rolled nice before bearings. Oh and another thing I took it out and ran it for a tank and when.I got home to inspect theres grease comin out of the bearings. I think they put 2 much grease in but bearings are not my specialty

 

[Deluge1]

How did it run with the new bearings? And yeah, if the bearings were over lubed the excess will get pushed out.

 

[maddmike]

Ran like a raped ape ! Just needs to roll better but if it ran good maybe just the bearings were to Damn full and workin its way free now

 

[Deluge1]

Yep, the bearings will loosen up after a few runs.