another servo question HELP

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
R

rampage idiot

Senior Member
Messages
1,338
Reaction score
0
Location
Indiana Pa.
Today I installed a HiTec HS-5645MG servo for throttle/brake I binded it again throttle works great, as does the brake, one BIG problem I have a killer bee 2 on it with stock redcat radio and receiver , when I turn off radio switch servo goes to full throttle?
 
Did you have to reverse the throttle channel? If you did, the failsafe is probably causing it to go full throttle. Try resetting the failsafe.
 
There is also a failsafe built into the receiver. Tiny reset button at the top of the receiver.
 
Deluge and RCDAD you be the man I mean men HA, you guys really no how to make a guy feel stupid I thought the only failsafe was that plug in one they sent with the truck, I just set the failsafe on the receiver and everything works great, Thanks alot both of you
 
I just installed the same setup as you. The killer bee V2 and 5645 throttle servo and it does the same thing. Full throttle but it only lasts about two seconds so not a biggy at all.
 
Back
Top