Any tricks for pulling flywheel?

[Gas Blast]

I'm rebuilding my first engine and just found out I need a flywheel tool. I am not going to have time to get to the LHS before this weekend. Any tricks or suggestions?

 

[FG ONICS]

make one, there really not that hard to make!
3 Bolts
1 bit of metal with 3 acuratley place holes drilled, & some nuts to stop the bolts just falling thru, simples yah

 

[WNCmotard]

Herein lies the beauty of it still being a weedeater at heart. Simply go to any auto parts store and pick up a 3 jaw gear puller the correct size, or alternatively any small engine shop should have a specific puller as well. Shouldn't be hard to find at all.

 

[Mike1970]

undo the nut but don't take it right off, then with a wooden or rubber mallet gentley tap the fins while holding the flywheel in the other hand, it will come off as its only an interferance fit - this works on mine anyway.

 

[CAR-KILLER]

hows this

 

[Gas Blast]

Awesome...thanks. I'll give it a try.

 

[Bigger the Better]

Nice car killer, I like that one the best. Just like the clutch one. Never thought of using it on the other side.
Added it to the collection.

https://www.largescaleforums.com/showthread.php?t=12001