anyone have there throttle stick on the mt?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
V

volitan

Well-Known Member
Messages
102
Reaction score
0
I have read a few places that The rampage MT has had a few issues with the throttle sticking.


Any of you have had that problem and what did you do to fix it?
 
I don't have a picture or anyhting like that I just wanted to see if it was a problem and if there was something I could do to fix it....if thats a problem that is
 
had the same problem today. had to readjust the throttle arm holder on the end of the servo horn. (has a hex screw and the arm goes through it)... my servo would push the carb arm about half an inch forward when i applied the brakes, and would go back to idle when i hit the go trigger.
 
i have problems, seen other with the same problem, with the wt-813. the shaft wears out i believe cause of the pump pressure on it and does not work smoothly. apart from that nothing else.
 
you have to have a good servo and adjust it to were it opens all the way but not forcing it. ya know what I mean? mine doesn't open quite all of the way but has no bind on it. try that mine hasn't came loose again since
 
fastlane said:
you have to have a good servo and adjust it to were it opens all the way but not forcing it. ya know what I mean? mine doesn't open quite all of the way but has no bind on it. try that mine hasn't came loose again since
Click to expand...
I know exactly what you mean.I have a dx3 so I will be able to ajust the end points for it.


Whats the best 3rd channel kill switch out there?


Whats the best throttle servo for it too?


Thanks
 
Thanks for the link!! wich kit do you think the best one out of the 5?


I guess I will operate the one that came with my V2 for a little bit until I upgrade all the servos.
 
No I wont use the one that came with the kit :) I will order one this week sometime.I like the kill switch from the radio...
 
Back
Top