baja cy 26cc won't start during break in!

[britton95]

So i am currently still breaking in my engine but this morning it started up just fine it was a bit rich. i revved it up a little then it cut out and i have went over everything plz help. i also have a ddm dominator v2 on it so idk if that makes a differnce on the carb setting or not cause base settings arent working for me.

 

[OuttaLuck]

Make sure its sparking and getting fuel check the fuel tank is breathing also carb setting will change when going from a stock exhaust to after market can also check for any airleaks around cylinder head and carb/manifold

Troy

 

[britton95]

It shouldnt be leaking air yet. I haven't even finished my first tank yet. I personally think it's the carb. i can't find the right settings for a tuned pipe. Cause like i said it started up right away that moring but it was runnin pretty rich since it wasn't warm yet so i gave it a little throttle and it stalled. So then it wouldnt start. I blew out all the fuel , cleaned the spark plug and still nothing.

 

[montreal31]

Turn down both screws (high and low) now crank it a few times it may or may not start at this point. Now reset to factory settings (manual) Then prime the bulb, then try to start without choke. It should start up after a few cranks... You may have simply flooded it running too rich. It happens every now and then, just repeat the steps.... Let me know how it goes....

 

[OuttaLuck]

https://www.largescaleforums.com/showthread.php?t=17630

 

[larryo]

HI how low is you ideal screw is it set to low?

 

[britton95]

got it

It was a fouled plug. It had spark so i didnt think it was fouled.