Baja windows

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
voo2doo

voo2doo

Well-Known Member
In Memoriam
PLUS member
Messages
8,915
Reaction score
538
Location
Flintshire,North Wales
Just looking through the forum and havnt seen a thread were folk were making their own windows so here goes.
I used a piece of 3mm plastic from ebay for about £3.
Then used Jacko's windows as a patten
Then put them onto the plastic and traced around them.
I cut the windows with my electric fret saw and finished the edges off with my table grinder.
Drilled the holes with a 4mm drill bit then ordered some 10.5mm cable clips also from ebay and bolted them straight on.
Job done!
J.
 
Take it your new baja is either a hpi or km and not a fg baja.
You can also make some inners or outters for the side of the baja, these are pretty expensive to buy new (£30), all you need is a strip of plastic and cut to size, i've got mine on the inside but my mate has his tie wrapped to the outside.
The car also comes with side scoops and have a plastic guard in them, but they seem too short so i've made some that fit in the scoops better, doesn't take long to do the lot and will keep a fair bit of grass out.
 
There's always the engine mesh mod too thats very useful, i've just bought a sheet of alu mesh from motorworld for £1.99. I'll be doing it when the weather changes for the worst as i don't want to be without a car, just in case i get chance to get out.
There is a thread on here showing how to do it.

Oh and put your receiver inside a ballon, this will keep any moisture from getting on your terminals.
 
these are some tinted red ones, i made out of a plastic storage box from the 99p shop you can get 3 sets out of one box and they come in red, lime green , blue, oh and pink.
 
Last edited:
Bloody hell, here we go again. :glare::ban:

Hey Paul they look well, can you get me a RED and a Lime Green and i'll sort the funds out the nxt time your over. Take it they are 99p each.
 
Back
Top