Baja wont fire.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
B

britton95

Member
Messages
23
Reaction score
0
Location
Oak Ridge, Tennessee
my baja won't fire i have set the needles back to default and everything. i checked the spark plug to i just cant get it to fire. sometimes it will fire for about three seconds but thats it! i'm about done with it...:(
 
Is the plug getting wet?
Is the HT lead on well.
Does the cap connect will with the wire.
Nothing's come loose on the coil?
Is that set OK - not too distant?
Try pushing the kill switch a few times - might be stuck.
Is there fuel in - stranger things - got to ask? !!
Is there a Killer Bee or equivalent - wire loose? Try removing it to fire it up to check.
Just a few ideas mate.

Good luck.
Al.
 
atom3624 said:
Is the plug getting wet?
Is the HT lead on well.
Does the cap connect will with the wire.
Nothing's come loose on the coil?
Is that set OK - not too distant?
Try pushing the kill switch a few times - might be stuck.
Is there fuel in - stranger things - got to ask? !!
Is there a Killer Bee or equivalent - wire loose? Try removing it to fire it up to check.
Just a few ideas mate.

Good luck.
Al.
Click to expand...

All good suggestions. Start with the plug.

!
 
Last edited by a moderator:
Killswitch is a problem Ive been having too so check it. The button likes to stick in. It needs to be all the way out which is like 1/4" or so.
 
try turning your needles all the way in and try to start it. if it is flooded it will fire and run high rpms then die.then set it back to factory and start it up. i could start my baja and tried this and that was all it was.
 
if you have a killer bee installed one of its main functions is if Rx battery get too low it will NOT fire up. found this out on mine, i charged my Rx batt up and she fired right up.
 
Back
Top