balancing Mt tires

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
S

scooby61

Well-Known Member
Messages
134
Reaction score
5
Location
Northern VA traffic pit of despair
Just tried to balance my Mt tires can't believe how far out these are from factory. I ran out of weights after two and they are not even completely done. While a test run shows significant improvement over the tires I've yet t loo balance. It seems a bit crazy that I had to use so much weight. The two I balanced used the same amount of weight on one side is there something else causing this? Can't see how rims and tires from the same mould could be that far out.
 
Same thing happened to me with my XT. What kind of weight you used?

I had to use the lead weghts you normally use in car rims.

It worked fine and it runs smooth without the tire wobbling. Painted black you'll have to look hard to find them.
 
You can get a tire balancer on ebay, probably make it yourself. There's videos on YouTube explaining the hole thing. Balancing the tires will make it run smoother and less locktite is needed. ;)
 
I used a du-bro propeller balancer and drilled out the little cone pieces for a 1/4 inch rod. Then I pulled one wheel hub and mounted that in the rim. Used fuel line to hold the cone pieces on then you spin the assembly and the heavy side will stop at the bottom.
 




I agree I balance all of my tires it does give you a much smoother ride less vibration longer costing time off throttle and helps make the tire wear evenly. You can alos buy a tire balanceer as I have shown above it has an arrow and you can see the weights at the bottom. A correct balance tire will never stop the arrow in the same place when you give it a small spin. If the arrow keeps stopping in the same place that means that the below the arrow part is heavy so add some weight to the top of the wheel until its balance.
 
While i was break-in my MT, I've noticed two of the wheels/tires were wobbling. So by reading this thread, these wheels CAN be balanced. Is there a balancer that work with stock MT tire?
 
infamous212 said:
While i was break-in my MT, I've noticed two of the wheels/tires were wobbling. So by reading this thread, these wheels CAN be balanced. Is there a balancer that work with stock MT tire?
Click to expand...
I built one from a great planes prop balancer. And yes it helped a great deal. I even balanced my losi 5ive wheels and it smoothed it out noticeably.
 
Back
Top