Belt drive

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
D

Dncswann

Member
Messages
21
Reaction score
0
I installed the x-can and the belt drive. The belt is inboard a little too much for me on the rear pulley. How do I adjust it out? Can't wait to get the truck on the ground?
 
Are you saying the belt is sitting almost at the outer edge of the clutch bell gear but the belt sits centered on the brake shaft gear?

If that's the case, no worries, it will never move from there...mine has ran like that for a gallon or so...
 
Well it sits more to the inboard side but I ran it on the stand and it was fine. I just wanted to know if that was normal
 
I think some guys are putting another washer behind the center tension spool to bring the belt out a little more.
 
Back
Top