I can not seem to get this belt right. I put the belt on bolt everything down and the truck will barely roll when pushed, seems real tight. I take the belt off and it rolls as should. I bought all new bearings for the gearplate and it still is too tight. I did notice the bearings do not have a real tight fit in the gearplate. Maybe the bearings are allowing the shafts to go crooked from the belt tension? I am at a loss here. Any ideas?
Did you have any luck with the belt you ordered? My MT barely rolls with the belt installed
It is so weird. I pull the belt off and it rolls great. I did notice my bearings don't have a press fit in the gearplate. Maybe they are a little crooked causing this problem.
Back the nuts off a fraction so that you have a little end play in the shafts.
I ordered a new gear plate. the bearings don't have a tight fit. Thinking maybe the shafts are being put at an angle from the tension of the belt. It rolls fine without the belt installed.
Mine was the same when I replaced the bearings
Register and gain access to Discussions, Reviews, Tech Tips, How to Articles, and much more - on the largest Large Scale RC community for RC enthusiasts that covers all aspects of the Large Scale RC!
Register Today It's free! This box will disappear once registered!
