Best steering servo

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Most use the hitec 5755. It's a great servo for the price. There are stronger higher voltage servos but are more $.
 
Thanks I thought I'd get one while my xt is out of order because after the fifth tank of gas the differential plate broke how it broke I don't know and after that we discovered two of the screws that hold the transmission cover on were stripped and also the receiver was bad I don't know if any of these problems are common or if I'm unlucky. How are the throttle servos?
 
My Xt is down as of today's schoolyard rampage where concrete and the front wheel put the death blow to my rebuilt stock servo. So I am going to either order the Hitec 5755mg or pick it up at a LHS, all depends on where I can find the best deal. Also going to get the kill switch that i have seen some posts on
 
RCGasMan said:
Are there differences in kill switches and how do they work?
Click to expand...
I am still researching I read a good post on the Super Bee Kill switch. a page or 2 back sure others can talk about it more, I will defintley have one installed before I run another drop of gas through mine, But I am waiting on my servo so have time lol
 
The Super Bee is an awesome switch. Works with all transmitters. It is plug and play.

Are there differences in kill switches and how do they work?
Click to expand...
It allows you to kill the engine if you run into trouble.
 
Last edited:
OK my bad. What comes with the rampages. It's about a 7" wire with a little oval shaped thing in the middle?
 
That is a failsafe it is suppose to control the servos in case of radio loss. Example apply brakes. They are useless if you loose power or have servo failure. Servos can fail during full throttle. You now have a 30 lb. missile heading off in some direction. This is where you must have the ability to shut it down.
 
Last edited:
Back
Top