bogging

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
M

mr.33trucker

Member
Messages
51
Reaction score
0
runs but boggs when doing the 3rd or 4th donut also what gears are people running with imex swamp dog tires am now running stock mt gears? running stock 23 cc engine v1 thanks 4 the help
 
Check your gas cap to make sure its venting properly. Also if the tank is low on fuel you could be pulling fuel away from the pickup in the center of the tank. Also if you don't have a pipe on that 23cc its going to bog some anyways unless you have an 8k spring on the clutch.
 
I was running my MT today when i noticed it was starting to bog until it finally stalled, and then it wouldnt start back up, started to check things out trying to find the problem, finally tracked it down to the gas tank, i noticed it was collapsing from internal suction. Loosened the cap to release the pressure and it started up first pull! I love how easy these trucks start! Anyway how do i go about fixing the previously mentioned problem so that it doesn`t continue to happen?....Thanks guys.
 
Wont that allow for sand and dirt to get in there than?...I thought about making the hole bigger but was worried it would create other problems, ive seen people with vent tubes on their caps, are they bought like that or are people fabricating them from scratch?
 
opps i forgot to add that i took some old filter foam from an old tmaxx and placed it under the rubber bulb. its still kinda messy cuz it lets fuel seep out if i flip it.


I might try the vent tube approach with a filter on the end.
 
This is what I did have not had a prob after the mod its just a nipple off a old carb


picture.php
 
Greeat mod!...So where does the other end of the tube go? I'm just learning all about these motors..Thanks
 
I just ran it to the filter and then up to the roll cage plate so its out of the way,and can pop it off the cap to refuel easy and clean.
 
Back
Top