Boots?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
M

maddmike

Well-Known Member
Messages
2,644
Reaction score
0
What are the boots I need for the axles and the diff cups.,, its for my dune runner. I want to put toobz on 2 as my cups are wearing 3months and they are bad... I seen that Phat fad sticky cvd grease I would use.
 
i've got the hpi boots on my d/r and they seem to work pretty well. they normally will stay in place without anything securing them. every now and than i'll find that one has slipped off after some hard running though and plan on using a bit of gasket sealer to hold them in place when i get around to it. i've read in other threads that,that is what some guys have used successfully. i also use that phatdad grease that's some good s**t it stays where you put it and on anything else you happen to get it on. one last note on the boots. if you run anywhere where there are alot of small rocks it only takes a heartbeat for one to jump in there and tear one of your boots to pieces.
 
rampagemt said:
I ordered the grey hostile boots how do I secure them to the cups
Click to expand...
They just slip on. Watch the tutorial on Hostile's website.

Sent from my SGH-T999 using Tapatalk 2
 
I was thinking like gasket maker . Shie goo would kick ass Idk if it would come off tho
 
rampagemt said:
Yes for the baja the redcats have slightly smaller diameter cups and axles
Click to expand...
I didn't know that. I assumed the diameter was similar. Try the zip tie as suggested and see if that holds before using something like gasket sealer.

Sent from my SGH-T999 using Tapatalk 2
 
I have used hostile blacks and hpi boots and never used anything to attach them I honestly believe the hpi's are better the hostiles always rip but I never tryed the grey ones
 
Back
Top