miniripper
Well-Known Member
:cup-1::cup-1:
[ame]http://youtu.be/goLJ5seeiFo[/ame]
[ame]http://youtu.be/goLJ5seeiFo[/ame]
BZM Micro and Losi 5ive T on board video
- Thread starter miniripper
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
jmolsen
Active Member
bzm
i got my 5 t yesterday, bzm, pipe, oniell 30.5 long rod put in 30.5 will break in today .the bzm is hard to get running right ive been told. any info on bzm would be app the 5t looks awsome, ill find out .
i got my 5 t yesterday, bzm, pipe, oniell 30.5 long rod put in 30.5 will break in today .the bzm is hard to get running right ive been told. any info on bzm would be app the 5t looks awsome, ill find out .
Mike1970
Well-Known Member
what's the engine size in this?
jmolsen
Active Member
28.5 bzm, 30.5 long rod full mod ,oniell
miniripper
Well-Known Member
- Thread starter
- #5
Set the needles at 1.5 turns each and go from there. They are dead easy to going correctly.
atom3624
Well-Known Member
What's the 'crackling' at sustained top revs?
Sounds like it gets up to top revs then bogs slightly - is it too rich?
Is the timing adjustable?
Al.
Sounds like it gets up to top revs then bogs slightly - is it too rich?
Is the timing adjustable?
Al.