jackobyte
Well-Known Member
I've decided to sell the Bzm TT so i can carry on funding this hobby..
I want £450 delivered via Paypal or cash on collection, buyer pays Paypal fees or do as gift..
It has recently had a re-build with a New Piston, O Rings and Ring..
New Insulator Block and Gasket Fitted..
The Red Head was replaced less than 4 tanks ago..
The engine over all has had a max of 14 tanks through it but now has a new piston kit and new insulator block..it will come as it is in the picture, 990 (15psi) carb, pull start, msd lead, clutch and filter which does need replacing..
Also included are a BNIP BZM 36mm piston ring and Head O ring which i'll add (over £16 alone)..plus i will include the optional Small engine brace that is needed if you decide to fit to a HPI Baja..See picture no: 4
These cost close to £700 new..
This is a very good engine and i've only started it up to make sure alls well since the rebuild, as you can see from the video it started on the second pull, it has now been removed from my Baja ready for its new home..
if you can't view via link then go to my Youtube site: jackobyte7 and look for BZM TT
You will see in the vid that the HT Lead was loose, in fact i forgot to tighten the plug up but it still started with it untight..
The only thing with the engine is that one of the exhaust bolt holes has lost its thread, ideally it would need re-boring/helicoiling but i have added a stud bar and connected a nut on the back which works very well and i've never had any problems running this way..See picture no: 3
Contact me as you never know a deal may be struck or if you just need a question answered then please ask away and i'll get back to you asap..
It will have too post 1st Class Insured due to the replacement cost if it gets damaged or lost..





I want £450 delivered via Paypal or cash on collection, buyer pays Paypal fees or do as gift..
It has recently had a re-build with a New Piston, O Rings and Ring..
New Insulator Block and Gasket Fitted..
The Red Head was replaced less than 4 tanks ago..
The engine over all has had a max of 14 tanks through it but now has a new piston kit and new insulator block..it will come as it is in the picture, 990 (15psi) carb, pull start, msd lead, clutch and filter which does need replacing..
Also included are a BNIP BZM 36mm piston ring and Head O ring which i'll add (over £16 alone)..plus i will include the optional Small engine brace that is needed if you decide to fit to a HPI Baja..See picture no: 4
These cost close to £700 new..
This is a very good engine and i've only started it up to make sure alls well since the rebuild, as you can see from the video it started on the second pull, it has now been removed from my Baja ready for its new home..
if you can't view via link then go to my Youtube site: jackobyte7 and look for BZM TT
You will see in the vid that the HT Lead was loose, in fact i forgot to tighten the plug up but it still started with it untight..
The only thing with the engine is that one of the exhaust bolt holes has lost its thread, ideally it would need re-boring/helicoiling but i have added a stud bar and connected a nut on the back which works very well and i've never had any problems running this way..See picture no: 3
Contact me as you never know a deal may be struck or if you just need a question answered then please ask away and i'll get back to you asap..
It will have too post 1st Class Insured due to the replacement cost if it gets damaged or lost..





Last edited by a moderator: