Can I get just the pin for the dog bone on MT?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
1

19cobra93

Well-Known Member
Messages
210
Reaction score
1
Location
Clinton, Utah
I lost a pin on the forward part of the rear dog bone that runs from the center diff to the rear diff. Can I get that pin separate? I'm sure I could find something that will work in it's place, but I'd much rather have the correct part in there.


On a side note, the MT is not a lot of fun when it's front wheel drive.
 
5/32 is almost the same diameter if you can't find metric. 4mm is .1575 and 5/32 is .1562. I got a dozen for like $2 at grainger. I also started taking a grinder and putting a small depression for the grub screw to set in to keep from losing them.
 
Thanks for the info guys. I was thinking a drill bit, or possibly a hardened hex driver or something similar. I'll work on it today. The weather's great so I plan to take advantage of it.
 
I cut bolts that fit and use those when I lost the pins, Redcat make rebuild kits as well....
 
Ffdfiretruck said:
5/32 is almost the same diameter if you can't find metric. 4mm is .1575 and 5/32 is .1562. I got a dozen for like $2 at grainger. I also started taking a grinder and putting a small depression for the grub screw to set in to keep from losing them.
Click to expand...
i've used this a few times, works great...
 
I use these they work great for all of the shafts. They have a flat machined on them too so the set screw grabs better.
 
U can use the needle bearings out of a automobile universal joint.there hardened.or weld your pins in and take out the grub screws that what i do and been working for over 5 tanks of fuel..
 
Back
Top