cpi big bore pipe fit

[blak__jak]

heres a pic after i got it all back together. rc dad if you look close you can see i finally got the belt drive on. i'll have to pm you about that cause i don't want everybody to know how numb brained i can really be. i do have to say i'm totally happy with the cpi esp and belt drive combo this baby screams. oh yea the blue bumper parts are the parts i made out of aluminum.





/monthly_2012_12/DSCN1598.jpg.0ab98dd6744755a51fdd9e32ace34462.jpg

 

[Guest]

Looks great!

 

[maddmike]

Looks awsome dude, nice aluminum lower cage supports!!! I need to make something like that!

 

[blak__jak]

the aluminum brackets are just 3/8 rod i picked up at lowes. i drilled and tapped the top ends than put the bends in and drilled and tapped the bottom so i could secure them to the frame and on the one side use a long enough screw to put a spacer on top of the frame and bolt the pipe down.

 

[maddmike]

Thanks for the tip. I need to do something like that for my jet pro v3.

 

[blak__jak]

man i'd like to see that jetpro mounted any chance on getting some pics up??

 

[maddmike]

Once I get it I will be sure to do it as it looks like it would fit better then my dominator welll ya the rear cage support I basically will have to build one so that aluminum rod is going to come in handy really soon. Once I get it I promise I will post pics!!!!

 

[Guest]

Look'n forward to seeing it mounted up.