ddm pipe on a smartech traveller

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
bandit

bandit

Member
Messages
19
Reaction score
0
Location
miami
i am trying to put a ddm pipe on a traveller with a 23cc zenoah in it but the pipe hits the roll cage. anyone running the ddm pipe? plz help
 
Yup.... that pipe hits the left rear roll cage...About the only thing you can do
is put a spacer behind the mount bracket to move it out a little.....
Bet your using a rear dom or rear torque pipe....Had the same issue on my firehammer...
worse you could do is have the bracket cut and rewelded......Some pipes fit better than others....You may want to go with a pro jet pipe...that should come stright back
along side the left side.....Ask Member Team chrome........Slawhammer
 
its actualy hitting the front left of the rear roll cage where the pipe turns around, it seems like its a tad short...i'll try to post some pics sunday or monday.
 
If I remember right Bigger The Better put some silacone or heat resisant rubber tubing
there..You may have to check with him on that...Slawhammer
 
I understand. I have the jetpro 2 mt5 pipe and have to cut my rollcage on the firehammer to fit it in. still not sure how I will bolt the front bracket hehe. getting to the pipe again shortly. the clones are close but the slight differences from fg makes some things a challenge. you might have to get creative.
 
damn its been a while since i have even touched or seen my r/c s. getting a new workshop delivered soon. 12 x 16 shed muahahaha. i will post some pics when it gets here and when i figure out how to post pics....
 
doing projects around the house and doing stuff with the family.

haven't gotten around to doin anything with my cars at all.... gotta make some time.
 
Back
Top