DGI Gears

[Rcflyer55]

I was looking on DGI website and they have gear sets.
22/59
23/58
24/57

I'm running the stock motor and a Jetpro pipe. Was thinking of changing the gears but not sure which to go with. According to the site I'll need to change the gas tank as well.

How do I figure out my top speed which the gears?
Has anyone tried these gears? Will I loose all my torque if I go for speed?

 

[Marky]

It'll probably take forever for the power band of the motor to hit with any of these. It's one thing to add pinion teeth but this multiplies the effect with the smaller spur. The torquiest option would be the 22/59 but you'd have quite a bit more top speed than stock.

 

[voo2doo]

In my opinion,Jetpros are only good for a little mid range and loads of top end.
If you want take off torque go for two teeth less on the spur and a DDM Dom.
J

 

[MTMIKE]

Why 2 teeth less on spur gear without changing pinion?

 

[voo2doo]

Why 2 teeth less on spur gear without changing pinion?

Oops,I did mean change the pinion as well as it would not mesh properly.
J

 

[Marky]

Less teeth on the spur will give more speed. You can go smaller spur with the same pinion. Move the engine, it'll mesh fine. Less teeth on pinion will give more torque.