dogbone pin?

[maddmike]

Any body have a link for the pins they buy for the dogbones or what size they are.

 

[Guest]

I've used old drill bits and trim them to the right length.

 

[maddmike]

Aww sweet that's a very good idea and FREE!!! THANKS

 

[Caveman80]

Tell u what I'll start saving the small bits I break from now on. Good call

 

[BoukeG]

Lol, me too! But still, what size do you use? 1mm? 1.5?

 

[Deluge1]

They should be 4mm, if I remember correctly.

 

[maddmike]

That seems right!

 

[KrashKrieg]

Part # 91595A167 ....4x20

http://www.mcmaster.com/#standard-dowel-pins/=ifhzm5

I ordered a pack of 50 long time ago, they also work for CVD pins

 

[maddmike]

^^^^^ those pins work awsome. You get 50 of em for under 15. Hell yes!

 

[Deluge1]

Yep. Great pins!

 

[Guest]

That will last you for awhile.

 

[Big Pitt]

Digging up this one because I have some issues with my CVD Pins...

They do not stay centered and they start to grind the hubs...

Should I grind my pins, in the middle to have a flat edge...?

Also, on my MT, the pins are only fixed with one srew per CVD and I use thread lock...but there are 2 screw holes one each CVD, so should I buy 4 new (extra) screws, to have 8 in total?

 

[Deluge1]

You should grind them down a bit in the middle. That'll lock the pin in place. I do that to all the pins that are held in with a set screw.