So here it comes again,
After fixing previous problem new one occurred.
There were no fuel coming, and it looked like something was stuck on carburato's fuel line. So with help of my dad we took off carburetor cleaned a little mesh, then putted everything back together. After that there was fuel coming.
After that I noticed that head was around 1mm off, so basically wasn't tight.
All you know there should be a thing that goes between motor and head itself.
SO we replaced that and putted that back together.
After all at first there were too much fuel. Then there were no fuel or not enough fuel. Then we gave up.
My dad knows a lot about 2 stroke engines since he were using them when he turned 16. So he think maybe the glower is bad...
Any ideas from you guys?
After fixing previous problem new one occurred.
There were no fuel coming, and it looked like something was stuck on carburato's fuel line. So with help of my dad we took off carburetor cleaned a little mesh, then putted everything back together. After that there was fuel coming.
After that I noticed that head was around 1mm off, so basically wasn't tight.
All you know there should be a thing that goes between motor and head itself.
SO we replaced that and putted that back together.
After all at first there were too much fuel. Then there were no fuel or not enough fuel. Then we gave up.
My dad knows a lot about 2 stroke engines since he were using them when he turned 16. So he think maybe the glower is bad...
Any ideas from you guys?
