engine

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Hi
after the engine working i open the remote control and the engine shut down
why?
what to do?
thanks

Is the engine new?
Was it smoking a lot?
When you 'opened' I presume you increased the throttle, does the throttle rod move, and open the throttle on the carburettor?
Is the plug lead connected onto the spark plug?
Is the battery charged - shouldn't affect the engine?
Not fired up, when you pull the chord, does it turn over OK, with some compression?
Is there fuel in the tank?
Does the primer bulb on the carburettor have fuel in it - half to 2/3 full?
Do you have a remote kill switch fitted to it?

A few questions for you - they will help!!
Al.
 
Is the engine new?No
Was it smoking a lot?White smoke but not alot
When you 'opened' I presume you increased the throttle, does the throttle rod move, and open the throttle on the carburettor???
Is the plug lead connected onto the spark plug?yes
Is the battery charged - shouldn't affect the engine? remote control battery full charge
Not fired up, when you pull the chord, does it turn over OK, with some compression?what?
Is there fuel in the tank?yes
Does the primer bulb on the carburettor have fuel in it - half to 2/3 full?-yes almost full
Do you have a remote kill switch fitted to it?yes new

A few questions for you - they will help!!
Al.
see my answer below on red mark
 
Is the engine new?
Was it smoking a lot?
When you 'opened' I presume you increased the throttle, does the throttle rod move, and open the throttle on the carburettor?
Is the plug lead connected onto the spark plug?
Is the battery charged - shouldn't affect the engine?
Not fired up, when you pull the chord, does it turn over OK, with some compression?
Is there fuel in the tank?
Does the primer bulb on the carburettor have fuel in it - half to 2/3 full?
Do you have a remote kill switch fitted to it?

A few questions for you - they will help!!
Al.

Please see my original reply.
Al.
 
Wiggle and or push your Kill Switch several times then check for spark.

I had a faulty switch on mine cause starting issues right out of the box.
 
Back
Top