Exhaust manifold gasket

[Mike4130]

I need a new gasket. I 'm thinking about the copper one, thoughts?


Anyone know where to get these quick?

 

[Guest]

The paper ones work fine for me.

Here are the copper. http://www.davesmotors.com/s.nl/c.885035/n.1/it.A/id.1698/.f

 

[cordy]

Take your old gasket to your local lawn mower repair shop and see if they can match it.If not then the above link will work.

 

[MrMeatHooks]

I use these bad boys. Re usable and practically fire proof! They wont blow out either.





/monthly_2013_06/583c60692f440_(KGrHqVHJEwFFylgeEwBRj3opBMY!60_57.jpg.e7b6426943e199911d54735d6a313935.jpg

 

[Motakitty]

I use the reinforced one from ddm. So far so good

 

[Shalako]

Not the copper. I just used them. Had a huge exhaust leak. Tons of fuel in my pipe. The reinforced ones from DDM are in now no problems. Don't think the copper seat as well. I don't recommend them.

 

[mnbaja]

I also used the ddm ones when I installed the Dom pipe on my mt,no problems.

 

[Motakitty]

Here it is

http://www.davesmotors.com/s.nl/it.A/id.7227/.f

 

[maddmike]

I use the ddm steel reinforced ones and no issues what so ever

 

[Michaels12]

I bought a sheet of Mr Gasket header type material from Oreillys auto. $8.00 but its enough for 50 gaskets i bet.... It has part #77 on the sticker. I used a hand type paper hole punch to make the holes and the port radius. I just couldnt wait to try out the CPI pipe.

 

[maddmike]

Might as well worst case it don't work then start over but I don't see that giving you issues

 

[Mike4130]

I ordered the reinforced one from DDM, Thanks guys!