FG Parts 4 A Mutilator 6

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Hate to say this but none that I know of. I had a mutilator purchased through hobbytown, as the picture looked like a carson/xtm/firehammer FG CLone, when it arrived I sent it back, as nothing on the chassis even looked the same as an FG let alone the other chassis. There may be some hardware, the tires and wheels, and engine and pipes, but overall its different.

Hope this helps a bit, also have you asked in the other forums?
 
I looked at the pics I had, and maybe the front end may share parts, but I am not sure of dimensions, also the rear upper and lower A-Arms and hubs may be alike, but it would be best if you tried to measure the items you are looking for. Also the Mutilator is a bit longer than the XTM/FG chassied cars, you can see it in the tank area, you have more room there than the FG/XTM cars.
 
The pic you posted is the mutilator, and you are correct. If you look at the pic, you note it is a little bigger, yet the arms and items may be alike etc. Noodle if you could , and this may sound like a pain in the Butt, take some parts off lay them on a sheet of paper and add the measurements, you can scan it in and post it and then we can compare the measurements to what we have, FG XTM Carson etc. But we also need the diameters for hingepins and also any area where there is a threaded screw (just measure the screw) THis should all help. And hopefully we would be able to help you and other mutilator owners. FYI the mutilator chassis is longer as it used to be advertised as a 1:5 buggy, which shows why the chassis has more length than the 1:6 FG / Carson Buggies.

Hope this helps
 
Back
Top