Flaky Kill Switch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
djbuzzard

djbuzzard

Well-Known Member
Messages
557
Reaction score
15
Location
Ashburn, VA USA
I have had recent issues with my MT...when I steer to right, the killswitch (Killer B v2) kicks in. It only happens when I steer in that direction. Once I steer left, the killswitch disengages. I'm thinking my servos (Turnigy S8166M x2) may be pulling too much amperage and tricking it to think the charge is low. Any ideas?
 
Ya man my stock servos are doing the same thing. I have a flysky tx and rx. The tx warns me when the rx battery is low which happens in less than 15 minutes of run time. The tx will beep when steering then super bee kills it a short while later. When steering the rx voltage goes from 6.1v to 4.2v. Let off the turn and back to 6.1v. So now I am putting in two hitec servos and a capacitor which somebody else suggested in hopes of resolving this annoying issue.
 
Back
Top