Flysky FS-GT3c, first impressions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
RCDAD said:
Yes those use the same receiver. It is also the same receiver that comes with the Redcats.
Click to expand...
you kidding?

gotta go try this later/tomorrow, as i lost half a day playing when my reciver died lol :rolleyes:
 
TerraKill said:
you kidding?gotta go try this later/tomorrow, as i lost half a day playing when my reciver died lol :rolleyes:
Click to expand...
Yep works most of the time. I had one receiver that I could not rebind for some reason. The others no problem, all three channels worked.
 
here's a couple pics of the usb adt. don't mind the ashes i use the ashtray too. these things come in handy for all kind of stuff.
 
Guantanamo Joe said:
When they put out a 4 channel, I will start putting lights on my rides... that is what I have been waiting for :D
Click to expand...
Just hack your gt3b (or get a gt3c) and get a four channel receiver. The hacked firmware allows you to go up to 8 channels. That seems strange, but you can assign like 0 or 100 signal to channel 4 using the ch3 trim buttons.
 
Last edited by a moderator:
BoukeG said:
Just hack your gt3b (or get a gt3c) and get a four channel receiver. The hacked firmware allows you to go up to 8 channels. That seems strange, but you can assign like 0 or 100 signal to channel 4 using the ch3 trim buttons.
Click to expand...
That is amazing. Its hard to believe it that simple.
 
Guantanamo Joe said:
When they put out a 4 channel, I will start putting lights on my rides... that is what I have been waiting for :D
Click to expand...
You know you don't need to use the kill switch on ch3. When I ran the GT3B I used ch for the light controller. If you piggy back one of the other channels you just shut her down by hitting the power button on the TX.
 
blak__jak said:
here's a couple pics of the usb adt. don't mind the ashes i use the ashtray too. these things come in handy for all kind of stuff.
Click to expand...
We got lots of those laying around for the phones, iPods & iPads.
 
RCDAD said:
You know you don't need to use the kill switch on ch3. When I ran the GT3B I used ch for the light controller. If you piggy back one of the other channels you just shut her down by hitting the power button on the TX.
Click to expand...
how did you do this! id love to have my 3rd channel free for other things;)

i did try using a the Y connection for the dual steering set up and i tryed tapping it into channel 1 and 2

and it kinda worked :rolleyes:

when i steer left i can start the engine, but when i turn right it kills it lol

same with brake and throttle lol
 
Last edited by a moderator:
Back
Top